![]() ![]() ![]() PetesASA(config-if)# interface GigabitEthernet1/2 PetesASA(config)# interface GigabitEthernet1/1 Backup the running config on the primary firewall. In this example I will use the following, This Link will use a crossover cable (Only available after version 7.0(2) before that you had to use a switch – I think!).Īlso I’m using the same link for LAN Based failover (heartbeat) AND Stateful replication.Įach interface will need its existing IP address, and an address to use whilst in “Standby”. In this example the firewalls were ASA5510’s and all interfaces were being used, so the Management port was used as the “Failover Link” (That needs a security plus license!). You have your PRIMARY firewall set up and running correctly (Everything works!). ![]() The same software versions are installed on both firewalls. The correct license’s for failover are installed on both firewalls. Hardware on both ASA firewalls is identical. You want to deploy 2 Cisco ASA 55xx Series firewalls in an Active/Standby failover configuration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |